There are requests for more detailed information coming in about the block press. Our original materials list works. However, we also appreciate the cost and difficulty in finding exactly what we recommended under some conditions. We have experimented with some lighter grades of materials and can suggest new minimums.
2″ square tubing 4 each 52″ long 11 gauge is best but we have had success with 16 gauge but we recommend 14 gauge minimum
4 each 12″ long recommendations the same as above.
2″ angle iron 2 each 49 1/2 ” long 1/4 inch wall is best, 3/16″ will work and is our recommended minimum
5 each 9″ long recommendations same as above These are for braces
1/4 X 8″ plate 2 each 49 1/2 ” long we have used 3/16″ instead of 1/4″ successfully 3/16″ is our recommended minimum
1/2″ X 8″ X 7 1/2″ plate 2 each our minimum recommendation on this is 3/8″ The piece isn’t square. The top measurement is 8″ and the bottom is 7 1/2″
1/2″ X 12″ plate 1 each 32″ long and 1 each 14″ long These are the lids for the chamber. We have used 3/8″ successfully and that is our recommended minimum
1″ acme threaded rod 1 each 36″ long We used 4 tpi (threads per inch) originally We have since began using 5 tpi. 4 tpi means less turns per cyle but 5 tpi means easier turning and more power. We recommend 5 tpi
1″ acme thread nut 1 each